You may well know that I have been recreating and printing parts for a while and thanks to Jasper and DucatiDad, I have been loaned a couple of parts to recreate.

So everyone knows, I like a challenge and 3D design is still a learning curve for me, so is 3D printing, but I am having fun and s doing it, so I thought I would share some of what I have been up to.

FYI, this takes me a long time, anywhere from a few days to a week or more, to design and test print as part. I don't have a 3D scanner as they are ludicrously expensive, so any part loaned me is measured by hand (and eye, when curves are involved) and reproduced as faithfully as possible.

I am not touting for work as I have a full time job looking after an EMEA technical team in the IT world, so this is a hobby, but I am always up for a challenge - it just may take a while!

Single Seat Bum Pads (Middle one is for SP3)

SPO/4/5 Single seat base plate.

Rubber Air Duct connectors for 1991 to 1994 models

SP2 Rear light surround (the 3D image is pure;y 2D and no perspective, so it looks wrong with the real part in front, but I assure you, it is pretty close!)

SP2 rear light surround (currently printing)