Side stand 907ie

Jack888

Is the 907ie paso side stand defo a straight fit to the 888?? Fits to the 888 mounting bracket??

Cheers

dudlington

On my 907ie PASO the side stand (Aluminium part) fits to a spigot on the steel frame. However I measured up and it seems the right part . Of course the other bracket with spigot that fits to the engine on the 851 and 888 does not exist on my bike. I cannot speak about the other model paso,s.

Jack888

dudlington wroteOn my 907ie PASO the side stand (Aluminium part) fits to a spigot on the steel frame. However I measured up and it seems the right part . Of course the other bracket with spigot that fits to the engine on the 851 and 888 does not exist on my bike. I cannot speak about the other model paso,s.

ok thanks, Ive already took the gamble and ordered a new 907ie stand to try,
Going by info on the net its a straight fit and its around an inch longer,
Fingers crossed 😱

dudlington

Yup it should be no problem.

Jack888

Just an update,

Got the 907ie paso stand home and its a straight swap BUT its just a tad to long on the standard 888, It causes the bike to site to upright and is on the verge of falling over the opposite side, fortunately i had 2 rear ride height adjusters that i just got for the rose joint ends on the hoop and after fitting these the bike sits absolutely perfect now,

Just in case any body else is looking to sort out there side stand the place in the USA have at least another 5 brand new paso 907 stands,

Cheers Jack

Mr.R

...and where in the USA are these available then Jack?

Steve R

Jack888

Mr.R wrote...and where in the USA are these available then Jack? Steve R

Was called for dinner when i posted or would have added the link if i had time lol 😱 There you go mate

Jack888

stafford

I have one on my road bike, works a treat.

Mr.R

Thanks for the link Jack.
I ordered one from the link and it arrived within a week from the USA without any import duty...
RESULT!
I've already modified it to take a grease nipple and shimmed it out to nullify any slop, on a alloy 888 bracket.
I'll bolt it onto my 955cc motor when I finish the build, which's underway as I type.

Steve R

Jack888

Mr.R wroteThanks for the link Jack. I ordered one from the link and it arrived within a week from the USA without any import duty... RESULT! I've already modified it to take a grease nipple and shimmed it out to nullify any slop, on a alloy 888 bracket. I'll bolt it onto my 955cc motor when I finish the build, which's underway as I type. Steve R

Nice one mate, I couldnt be happier with mine, Sits absolutely perfect now, I used to have to pick my spot before parking up before lol,

955 Sounds interesting, Be great to hear a little about the build when your done

Cheers Jack