Kashby
Hi, I'm wanting to adjust the front fork height through the top yoke from its current 20mm to the standard 10mm, is there an easy way to do this or is it a full front end strip down?
RWG
If your talking lowering Forks though yolks then it is quite easy, removed lower fairing support Engine (jack) as it is now then lossen all clamp bolts on yolks and raise jack until Forks slipe down to decided height. Then tighten yolks and job done.
Hope I have not miss under stud your question.
Regards
Paul
Kashby
Hi, yes you have understood my question correct, so if I remove the bottom fairing where do I use the jack, under the engine or somewhere else?
sagot
Yes, with block of wood.
Or use a strap or two from a good ceiling hook...
