Wanted cable harness 888 sp4 , sp5 , spo

dudlington

I know it is a long shot but does anyone have a decent (or new) cable harness for a 888 sp4 , sp5 or SPO running the P8 ............or does anyone know of an alternative that could be lightly modified that will do the trick. During the resto of my SP4 I thought I had one but found out it is the wrong type. The one on the bike was hacked about so much (To put the ECU up front) and bodged that I would only use the connectors , the wiring is the worst I,ve seen.

DESPERATE .........as the project is on hold until I can source one.

stafford

I'll have a look

marvin

I have a good harness from a '92 851 , P7. Don't know if it's the same or not??

dudlington

Marvin

I believe the 92 851 came with single fuel injector , hence the P7 computer. The SP3 , SP4 , SP5 and SPO all came with the double injectors per cylinder for the fuel injection , hence the P8 computer.I did think of using this as a basis to create the right wiring loom and adding the extra wires for the extra injectors as well as the P8 computer. It could be the closest I could get so it might be an alternative. Please confirm if anyone thinks this is right as it sounds logical. ?????.

Stafford Please have a look

Thanks all.

marvin

I think the SPO had only one injector per cylinder.

stiglarsenDK

marvin wroteI think the SPO had only one injector per cylinder.

Yes SPO has a small injector harness/connector to main harness- single injectors
SP5 look very similar, but w small dial harness / dual connector.

As far as i remember, 851 92 and SP4 has no small harness, but cables w single respectably dual connectors.

I think i have a 851 92 harness left over... should be no big deal to all the extra wires ..

dudlington

With help from A J Corse looks like I,ve found the main rear part of the loom (I have already the small rear part ). Just the front bit(s) to find. Keep searching guys there must be one out there or something close.

mikesps

dudlington wroteMarvin I believe the 92 851 came with single fuel injector , hence the P7 computer. The SP3 , SP4 , SP5 and SPO all came with the double injectors per cylinder for the fuel injection , hence the P8 computer.I did think of using this as a basis to create the right wiring loom and adding the extra wires for the extra injectors as well as the P8 computer. It could be the closest I could get so it might be an alternative. Please confirm if anyone thinks this is right as it sounds logical. ?????. Stafford Please have a look Thanks all.

It can be a but confusing, but the P7 can run twin injectors, it is used on an SP3. With an SP3 you can swap from a P7 to a P8 provided you have a suitable P8 chip.

Mike

italian888

pm sent