Swing arm end caps

Digger

Looking for a pair of swing arm end caps (although one would do). The gold anodised ones. For 1993 888 Strada.

Thanks

Jason

ducati dad

Don't forget that the N/S one is different to the O/S one.

Digger

ducati dad wroteDon't forget that the N/S one is different to the O/S one.

Wasn't aware of that so thank you DD. OK, well a pair or the one on the chain side. :-)

900SL

Sold: Pending settlement

Genuine factory Corse carbon items.
..Never used..
Can post to UK for £220...

Digger

900SL wroteGenuine factory Corse carbon items. ..Never used.. Can post to UK for £220...

Thanks for the offer but a bit too flash for my Strada.

Looks like they are still available new from Ducati. Should know shortly.

henk

You can't have to much carbon on your strada.
That is not a bad price for original ones.

Henk!!!

Digger

henk wroteYou can't have to much carbon on your strada. That is not a bad price for original ones. Henk!!!

It would be the only bit of carbon !!

Anyway, have ordered them new from Ducati

37310041A - Left hand - £27.94
37310021A - Right hand - £20.39

Thanks for everyone's input. 😄

ducati dad

900SL wroteGenuine factory Corse carbon items. ..Never used.. Can post to UK for £220...

If anyone thought these were expensive [ I don't] then these will make your eyes water...
http://www.ebay.co.uk/itm/Ducati-Corse-Carbon-Swingarm-End-Caps-851-888-/161395639675?hash=item2593ee057b:g:utAAAOSwQItT7jM4

sagot

WTF! $1100.00
I have a sheet of Pre Preg in the back.
I'm off to go make a mold on my CNC.
A couple hours on the mill and 4 in the oven!!!

900SL

That's good news....Just be mindful of the left and right sides for them....left side is thinner on the inner edge for sprocket bolt clearance.
Likewise the anodising colour will vary at production I've two set's of originals and each piece is a different shade of gold...then allowing for nearly thirty' years of fading of the original on the bike mixed with some road grime and chain lube then they're going to have a variation....
I'm sure this will make sod all difference to the way they function but just for the OCD Ducatista who ride amongst us...

nine16

sagot wroteWTF! $1100.00 I have a sheet of Pre Preg in the back. I'm off to go make a mold on my CNC. A couple hours on the mill and 4 in the oven!!!

Look at the rest of that seller's items/prices. He is known for listing them several hundred percent over typical value. They always have an "offer" option though. :wink