nine16
Anyone know a source for a spacer replacing the 17mm speedo drive? Or have dimensions to make one up?
JSR29
The spacer is 35mm long. The rest I'm sure you can figure out from the demensions of the axle, fork boss and wheel bearing. I didn't find one when I was looking and had a friend turn one up.
seven4nineR
I basically just copied the critical dimensions of the speedo drive when turning one up out of ally. You can slim down the body as much as you feel comfortable, the only "semi-tricky" bit is recessing the face to clear the drive "tangs" in the wheel centre. If you were keen I guess you could remove these tangs and make the job even simpler, but might have to factor in a new seal to do so.
I'd send a pic but I'm working away from home for the next couple of weeks.
