+ Post New Thread
Page 2 of 5
FirstFirst 1 2 3 4 5 LastLast
Threads 21 to 40 of 90

Forum: Corse Technical

  1. Sticky Thread Sticky: Technical

    This section is set up for detailed pictures or discussions about any technical aspects of Corse bikes. Pictures of particular parts, questions of...

    Started by MarkT, 08-10-2011 08:35 AM
    • Replies: 0
    • Views: 3,144
    08-10-2011 08:35 AM Go to last post
  1. Battery size for 888r ?

    While waiting to find an original CF Battery Tray for the 888R project, I did some prototyping today 'Card board technology', planning to make an ALU...

    Started by stiglarsenDK, 10-30-2016 03:16 PM
    • Replies: 2
    • Views: 568
    11-09-2016 08:43 PM Go to last post
  2. Early CF tank on later 888 Frame

    Hi Found this beautiful early 91 CF NOS tank, and plan to use it for a 888R main frame/sp4-5 Alu rear frame..I wonder if a flip tank conversion /...

    Started by stiglarsenDK, 08-03-2016 03:17 PM
    • Replies: 8
    • Views: 1,488
    10-31-2016 08:06 AM Go to last post
  3. Yoke sets finally done, MG/Alu combo w 25 mm Offset

    Hi Starting point : 2 lower NOS MG yokes (25 MM off set / 56 mm Bore (205 MM) .. but no MG Top Yokes w 25mm offset, nor special pins to be found...

    Started by stiglarsenDK, 10-25-2016 03:03 PM
    • Replies: 3
    • Views: 685
    10-26-2016 01:24 PM Go to last post
  4. 888/926 racing head, how to recoginze?

    Hello, I have at home two heads empty, one marked in the top 92 and one marked 93, they appear like racing heads because the combustion chamber is...

    Started by workslorenz, 07-13-2016 01:48 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 3,092
    07-18-2016 11:02 AM Go to last post
  5. Period correct brake master cylinder?

    So I've seen plenty of info/photo's of the sexy billet P4 calipers on the Corse bikes but not so much on the master cylinders of the time. Anybody...

    Started by seven4nineR, 04-27-2016 03:35 PM
    • Replies: 8
    • Views: 1,850
    05-01-2016 01:28 PM Go to last post
  6. advice for carbon tank,connector,hoses and clamp

    it's impossible to use the standard aba clamp on the connector into the racing tank. i've made a special clamp. i use standard gates summersible...

    Started by tiz851, 03-27-2016 02:34 PM
    • Replies: 4
    • Views: 1,418
    04-10-2016 03:51 PM Go to last post
  7. Radiator holder dim's

    Im after a good picture and "hole to hole" distance (mm) for the radiator holder ref picture. I belive they are 20x4mm profile like the strada...

    Started by stiglarsenDK, 03-25-2016 07:49 PM
    • Replies: 1
    • Views: 947
    03-29-2016 06:48 AM Go to last post
  8. Ohlins 89 to 94 rear shock data

    Found these data sheets rooting through paperwork to see what is needed to refresh a preload adjuster. Hope they are of use Guy851

    Started by guy851, 01-25-2016 02:55 AM
    • Replies: 1
    • Views: 865
    01-25-2016 02:44 PM Go to last post
  9. Corse fuel line quick couplers

    http://www.ebay.co.uk/itm/290798705458?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 Saw these if anybody is looking Guy851

    Started by guy851, 02-10-2013 11:27 AM
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 8,066
    01-23-2016 05:07 AM Go to last post
  10. Ohlins steering damper.

    Hi all, I find this steering damper, Sticker on damper is OEM Ohlins and anodize color looks also like old Ohlins part, but on the parts is...

    Started by ajcorse, 01-08-2016 11:47 AM
    • Replies: 2
    • Views: 980
    01-09-2016 03:10 AM Go to last post
  11. carbon valve covers

    Came across this set... never seen them before, can any one share some history on these ...

    Started by stiglarsenDK, 11-23-2015 09:50 AM
    • Replies: 8
    • Views: 1,644
    11-25-2015 08:37 AM Go to last post
  12. >> Corsa throttle body 1993-1994: pics and details

    Hi, I am looking for pics of Corsa 1993-1994 throttle body. Has anyone good pics and technical details to share. Cheers

    Started by toospeed, 11-07-2015 09:52 AM
    • Replies: 3
    • Views: 922
    11-08-2015 01:06 PM Go to last post
  13. V Piece Corse - Fit on Strada side panels ?

    Planning the fit of the Corse size radiator on my ST4S/SPS racer.. Will this V Piece fit the Strada type side panels ? or will i need other...

    Started by stiglarsenDK, 11-05-2015 05:30 AM
    • Replies: 0
    • Views: 566
    11-05-2015 05:30 AM Go to last post
  14. Alignment for rear wheel 3 spokes Marchesini

    Hello there, Question again for Corsa building. I would like to know if someone has the original spacers for the sprocket carrier (currently...

    Started by BABA, 05-08-2015 05:16 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 5,037
    10-21-2015 03:06 PM Go to last post
  15. Clutch and brake fluid reservoirs RACING

    Hi, some models of 851 and 888 ( either SP models or Racing) have the fluid reservoirs mounted on the top triple clamp. I like that look for my...

    Started by wolfgangh, 12-07-2013 12:30 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 3,304
    10-06-2015 02:44 AM Go to last post
  16. Alternator cover RS Single phase / P08

    Turning to the exclusive corse section for help.. I planning to use this cover for a 926/955 engine build (93 race case w 102/96 barrels, rest from...

    Started by stiglarsenDK, 09-26-2015 09:32 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 2,733
    10-04-2015 04:54 PM Go to last post
  17. Rear mounting for the 851 Racing's fuel tank

    Hello, I would like to know if someone here could help me with clear pictures and for each parts of the rear mounting of the racing fuel tank for...

    Started by BABA, 09-05-2014 11:04 AM
    • Replies: 8
    • Views: 2,127
    09-26-2015 02:27 AM Go to last post
  18. 851 Racing '91 - magnesium alternator housing?

    Guys, i'm curious to know - did the 851 Racing '91 come with a biscuit coloured magnesium alternator housing, or was it a black painted one? I've...

    Started by tom.i, 09-20-2015 04:13 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 2,689
    09-22-2015 06:56 PM Go to last post
  19. Corse Ohlins steering damper dimensions

    I have a rather unusual request. I am looking to install an Ohlins steering damper on my 888 and with the help of Steve Bailey, I have acquired the...

    Started by nix510, 08-31-2015 12:22 PM
    • Replies: 3
    • Views: 951
    09-01-2015 08:25 PM Go to last post
  20. Magnesium cam mounts and rocker covers

    Looking for mag rocker covers and cam mounts. 23520101B 23520111B 23520131A I thought the 37mm valves were hard........... The final...

    Started by Ducal, 10-22-2014 07:29 AM
    • Replies: 1
    • Views: 946
    07-26-2015 08:02 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts