Forum: Corse Technical

G’day, Can anyone give clarity as to which engine casings are compatible with late 888 Racing. I want to build 955, I have most parts but not sure...

Awhile back, I attempted to purchase from a member here what was described as a rare, early version, 851 Ducati Corse/Racing Carbon Fiber tank. I...

CIAO GUYS; I propose the motorbike of one friend of mine. offers are accepted correct for the value of the motorbike !!! the motorbike was bought...

My 955 engine is about there (full Corse spec inside out) I'm missing the injector unit and wonder what ill need not to make any compromises there...

Last missing part of the harness puzzle , "swich" 53910101A.. It looks like a black tube, and connects to the main harness and attache to the...

Hi, having almost completed the 916R harness set to be used on the 888Racer project, but missing the instrument cable... it may be 51011051A, but not...

Not sure what these connectors are called, but im after a few sets.. to make a RACE 916R harness work on the 888R project... (916R seem very close to...

G,day, does anyone know the difference between the beltside magnesium cam mounts 23520101A and 23520111A, obviously one is inlet and one exhaust but...

Does any one have a close up foto of the 91 racing seat pads, ref picture ?... specially the back side is of interest I belive they are made with...

Got a repro dash as pictured but can anyone confirm the sizes, I only have temperature gauge from road bike but no tacho, however the hole fot the...

Does anyone have these punches for sale Part numbers 887130874 887130879 887130875 Or alternatively has anyone got exact measures to get...

Hello to everyone, I have an sp4 with a strange engine. The carter is G9. The heads are marked M with 91. I know sp5 have G heads but not sp4...

Does this look periode correct ? Used from when to when ? Did they have 10K read line or no red line at all ?

Any advice would be appreciated wrt source, type, power (max) Picture added... ;-)

Help needed. My rear brake pads to my 888 Racing are worn and need replacement. Does any one know the original manufacturer, part number,...

which is the od (the part who is centerd in the cases)of the 96mm cylinder? 102mm? is the same for all? same question for the height,which is?...

Does anyone know, where Ducati sourced the piston rings from ?

While waiting to find an original CF Battery Tray for the 888R project, I did some prototyping today 'Card board technology', planning to make an ALU...

Hi Found this beautiful early 91 CF NOS tank, and plan to use it for a 888R main frame/sp4-5 Alu rear frame..I wonder if a flip tank conversion /...

Hi Starting point : 2 lower NOS MG yokes (25 MM off set / 56 mm Bore (205 MM) .. but no MG Top Yokes w 25mm offset, nor special pins to be found...