Forum: Corse Technical

Finally picked up the tank outlet/reversion fittings I had made, not a cheap exercise but made to OEM Spec. If anyone is in need of a set PM me for...

I’ve got a spare clutch Spacer if anyone needs one ? Part # 71310741B

Has any body got a reference to hand for the bearing on the three spoke Racing Marvic axle rear? Thanks nick

Can some one confirmif these pegs are from 93-94 race, gear shift side?

Can somebody tell my if there is a difference in the corse rear caliper holder for the 851 and 888? With difference, i looking mainly to thickness...

Can some one please confirm the external diameter of the Corse Racing rear wheel spindle / axle, and at what point on the axle it is determined...

I’ve got a spare green magnesium cam mount Belt side ( not for sale ) BUT would exchange for the opposite side ( Green magnesium left/ gear lever...

Got a repro dash as pictured but can anyone confirm the sizes, I only have temperature gauge from road bike but no tacho, however the hole fot the...

Hi, a friend of mine some days ago bought a 888 racing frame, with correct frame number from one of the few '93 customer bikes built by Ducati. Now...

G’day guys does anyone have a spare OEM 45110091A stretching pin please ?

Does anyone know what the Endurance Speicification is for these bikes ? I guess they needed lights , but what about tank and other parts ? We’re...

This ebay decal says 25-27mm but I have seen ones that say 20-25 and 25-30, all claim to be for the 851/888. What does an original, factory fitted...

If anyone needs the spring in the reversion tank fitting I have a couple spare as I got tank fittings made.

Here a question for corse experts: The G inlet camshaft marked OA for horizontal cylinder exist also in the "long" version extended to drive the...

Does anyone make base gaskets at 1.6 mm to fit the 926/955 Corsa cylinders. Got an FBF built 955 which has had a full rebuild but had 3 copper base...

Does anyone have a spare 17210641A ( 1st gear driven ) please ?

You probably have seen it on the internet, but some Ohlins FG9030 from Doug Polen are for sale. I'm not interested in the fork, but I was wondering...