+ Post New Thread
Page 9 of 128
FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 59 109 ... LastLast
Threads 161 to 180 of 2549

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 20,191
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 8,304
    04-04-2012 05:22 AM Go to last post
  1. Electronics Tacho from monster

    Will this tacho from M900 work on a P08 based setup ? Grazie mille

    Started by stiglarsenDK, 05-11-2017 06:22 AM
    • Replies: 5
    • Views: 391
    05-30-2017 02:59 PM Go to last post
  2. 91 851 extended mirrors

    I am looking to see if there are any extended length mirrors for my 91 851. I know Vitaloni had mirrors for the 851/900, would like to know if they...

    Started by bikerinneb, 05-14-2017 08:13 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 822
    05-17-2017 07:56 AM Go to last post
  3. Duplicate key

    Hi does anyone know if spare keys are available from Ducati for 888 ? Cheers

    Started by nodrog, 04-27-2017 08:31 AM
    • Replies: 9
    • Views: 396
    05-16-2017 11:48 PM Go to last post
  4. Radiator Issues on '91 851

    Hoping for some advice / help. I have a 1991 851 Strada which had a leaking radiator in several places. I couldn't find a new one so had my old one...

    Started by cmd, 05-16-2017 12:31 PM
    • Replies: 1
    • Views: 193
    05-16-2017 03:18 PM Go to last post
  5. Tricolore woe's

    Hi Folk, Just rolled out Tricolore intending to run for next month or so, No Start. Starter solenoid making 12v on out post to starter motor...

    Started by RWG, 05-15-2017 11:52 AM
    • Replies: 2
    • Views: 229
    05-15-2017 03:29 PM Go to last post
  6. Engine refurb

    hi, I am stripping my 888 engine down primarily to work on the valve gear and clutch. The finish on the heads and casings is in poor condition and in...

    Started by rgpjs11, 02-27-2017 06:16 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 959
    05-09-2017 03:21 PM Go to last post
  7. Clutch - steel plates vs basket, purpose of CUT on outer diameter ?

    A quick check on the clutch before preparing the SP5 special for the season. The basket is ALU (to be replaced as quite worn), Friction plates...

    Started by stiglarsenDK, 04-30-2017 03:51 AM
    • Replies: 5
    • Views: 326
    05-03-2017 06:29 AM Go to last post
  8. Toasted cans... New damping material, best material and source ?

    After a great Sunday ride, i noticed some heat spots on the CF cans coming back and knew what i was up for : a small repacking project ... ...

    Started by stiglarsenDK, 04-10-2017 04:53 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 637
    05-02-2017 07:04 PM Go to last post
  9. 888 Showa rear suspension spring.

    I've backed the preload almost completely off and the compression damping off. Still get 'jack hammered' in the saddle on a bumpy road. Has anyone...

    Started by desmo54, 04-27-2017 01:07 AM
    • Replies: 3
    • Views: 212
    04-27-2017 07:34 AM Go to last post
  10. Cometics gaskets again.

    Just an update on my head gasket problems i have had on my 984 desmo Quattro. I always had a very small leak at the head. Enough to smell coolant but...

    Started by vij, 04-20-2017 04:45 AM
    • Replies: 2
    • Views: 196
    04-23-2017 02:47 AM Go to last post
  11. ducati sp4 correct eprom

    Hi to all the members, I own a sp4 with many racing components. I would like to know if somebody of you knows the eprom number for a 1992 sp4. I...

    Started by gina, 03-29-2017 11:38 AM
    • Replies: 7
    • Views: 387
    04-21-2017 10:17 AM Go to last post
  12. Carbon repair

    Has anyone successfully repaired carbon here ? My stand slipped and made a break for freedom through my rear hugger 😬. It's cracked in two places and...

    Started by Nattyboy, 04-19-2017 05:15 PM
    • Replies: 2
    • Views: 157
    04-19-2017 07:48 PM Go to last post
  13. Front discs large offset type for Marvic Magnesium wheels

    Have put this info now in the technical section. After much searching I have found a very good alternative that I am happy with and could help...

    Started by dudlington, 04-11-2017 03:33 AM
    • Replies: 5
    • Views: 301
    04-13-2017 12:38 PM Go to last post
  14. corse intakes/space to fairing

    With the corse cf intakes, should the front fairing but right up against them or should there be a gap? If so, how big?

    Started by nine16, 04-13-2017 02:32 AM
    • Replies: 1
    • Views: 140
    04-13-2017 03:19 AM Go to last post
  15. Fuel line sizes

    What are the sizes of the 2 internal drain/vent lines in an aluminum 851 tank? Are they smaller than the high pressure lines? I'm having issues...

    Started by nine16, 04-11-2017 12:32 AM
    • Replies: 2
    • Views: 162
    04-11-2017 03:32 AM Go to last post
  16. What a day. but!

    But! Had SP4 out today, bsolutly brilliant, approx 230 miles on way back 20 miles from home started to get brake judder when applying brakes. I...

    Started by RWG, 04-08-2017 03:10 PM
    • Replies: 1
    • Views: 206
    04-10-2017 04:44 PM Go to last post
  17. Chain damaged casing... here is how NOT to fix it...

    Spend a few hours last night breaking a 888 strada engine 93' which will serve as donor.. I allready knew the casing was damaged...so no surprises...

    Started by stiglarsenDK, 03-31-2017 06:43 AM
    • Replies: 4
    • Views: 296
    04-02-2017 06:18 AM Go to last post
  18. Ducati 851 Engine tune , cylinder head and chip ID ????

    Just wondering if someone could enlighten me on cylinder head ID and chip ID Ducati 851 S3 First photo is cylinder head id FT with another letter...

    Started by dudlington, 03-28-2017 09:41 AM
    • Replies: 3
    • Views: 260
    03-30-2017 04:08 PM Go to last post
  19. SPS / SP4 frame and engine numbers

    Hi pals, I've found for sale something I think is an SPS or an SP4. Does anybody know the engine and frame numbers for these bikes? Thank...

    Started by BARONROJO, 10-20-2016 05:15 AM
    • Replies: 8
    • Views: 958
    03-30-2017 02:46 PM Go to last post
  20. Frame choice for 888 naked cafe build

    Hi guys, new member just after a little info. I am planning a 888 style naked/cafe build, but still undecided if it will be an air cooled or...

    Started by 63eh, 01-15-2017 06:59 AM
    • Replies: 9
    • Views: 1,538
    03-29-2017 06:21 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts