+ Post New Thread
Page 8 of 128
FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 58 108 ... LastLast
Threads 141 to 160 of 2549

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 20,175
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 8,289
    04-04-2012 05:22 AM Go to last post
  1. EPROM Available for troubled 888?

    I've just restored my 1993 888 and am now pulling my hair out. The bike dies when it comes up to temperature or when I put it under load (like try...

    Started by Amovida, 07-07-2017 09:41 AM
    2 Pages
    1 2
    888
    • Replies: 16
    • Views: 710
    07-18-2017 01:57 AM Go to last post
  2. Water AND oil temperature gauges on 91 851 strada?

    Hi all. Have recently bought a 91 851 strada, and a previous owner has installed an extra temperature gauge in the dashboard and customized the...

    Started by Desmo851, 07-13-2017 06:11 AM
    • Replies: 6
    • Views: 259
    07-16-2017 11:18 AM Go to last post
  3. 900 ss footerst on 888

    Hi would love to have my hangers on the 888 a bit further back and high up. Am reading that 900 ss one would fit and serve the scope. Is this...

    Started by diabolik, 07-12-2017 03:19 AM
    • Replies: 2
    • Views: 229
    07-12-2017 07:46 AM Go to last post
  4. delays in acceleration

    Great winter's day here: a mild 12c so a 250k ride but at 4k rpm cracking the throttle there was a lag an a splutter like running on one plug. So...

    Started by Whitto1, 07-09-2017 01:55 AM
    • Replies: 4
    • Views: 230
    07-11-2017 12:23 AM Go to last post
  5. Coolant loss diagnosis?

    The Sp runs well at 50c then when stopped it climbs to 100c and the coolant voids out the expansion cap. I suspect the thermostat not opening early...

    Started by Whitto1, 05-29-2016 06:43 AM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 2,351
    07-10-2017 05:08 PM Go to last post
  6. '93 888 Strada rear shock advice

    Just been told that the lower link has too much play and needs replacing, however, there aren't any available through Ducati. Does anyone have any...

    Started by Bridgland, 07-07-2017 11:05 AM
    • Replies: 1
    • Views: 214
    07-09-2017 03:43 AM Go to last post
  7. Can't find the sprocket torque specs

    I want to change the sprockets and chain, but I cannot find the torquesettings and if/which Loctite is required. You'd expect this kind of job would...

    Started by BoxerMartijn, 06-24-2017 07:55 AM
    • Replies: 1
    • Views: 203
    06-25-2017 07:01 AM Go to last post
  8. Chain hits the tyre

    The chain of my '92 851 is very close to the tyre(Pirelli 180-55), less then 1mm and already has cut some rubber. What's the normal space between...

    Started by BoxerMartijn, 06-08-2017 08:33 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 626
    06-25-2017 04:29 AM Go to last post
  9. Speedo drive

    I've had a search, but there's nothing conclusive. Is an ST4S speedo drive compatible with the 851 speedo. I want to use the ST4S front wheel, axle...

    Started by ducati dad, 07-18-2014 06:46 PM
    • Replies: 7
    • Views: 799
    06-24-2017 03:07 PM Go to last post
  10. 851'92 stickers size

    I'm starting the restoration of my 851 biposto '92 but I have a problem with the stickers. I don't know the right measurements of all stickers I...

    Started by alessio851, 06-22-2017 01:35 PM
    • Replies: 2
    • Views: 167
    06-24-2017 03:39 AM Go to last post
  11. Fuel Tank Pressure relief valve seal

    Hi, does anyone know a source for the nitrile seal that goes in the pressure relief valve that fits in the bottom of the 888 tank?

    Started by Jasper, 06-17-2017 06:15 AM
    • Replies: 8
    • Views: 571
    06-21-2017 06:20 PM Go to last post
  12. 91 851 R/brake pin

    Hi all, I'm rebuilding an SP2 and missing the rear caliper mount pin, which goes through the swing-arm Pt# 037740070. NLA and exhausted almost all...

    Started by JackBenny, 06-15-2017 07:44 PM
    • Replies: 3
    • Views: 349
    06-17-2017 04:47 AM Go to last post
  13. Marchesini 5 spokes

    Ok folks, I'm sure this has been done to death but I can't find the definitive answer on here! I have just bought a set of Marchesini / Brembo 5...

    Started by windycorner, 06-07-2017 01:42 AM
    • Replies: 7
    • Views: 561
    06-15-2017 03:42 PM Go to last post
  14. 1.5mm collets

    I am on the valve shim job again and would like some new collets. Are there any suppliers of “good quality” 1.5mm valve collets that fit well and...

    Started by Tim, 06-05-2017 06:54 AM
    1.5, collets
    • Replies: 4
    • Views: 356
    06-12-2017 07:20 AM Go to last post
  15. 888 Corsa Tank Dimensions

    I am looking at converting an SP5 Tank to 888 Corsa. Can Anybody give me teh dimensions from under the tank please? ie width of seam where it flares...

    Started by Jasper, 06-08-2017 08:24 AM
    • Replies: 4
    • Views: 289
    06-10-2017 02:14 PM Go to last post
  16. New owner of #17 SPO LTD looking for a seat

    Hey Guys, I recently purchased SPO LTD #17 out of a collection in Pennsylvania. It has been sitting for 15 years but I had my race mechanic get...

    Started by DucFiend, 06-07-2017 01:15 AM
    • Replies: 0
    • Views: 135
    06-07-2017 01:15 AM Go to last post
  17. 900ss Speedo

    Hi I'm running a 25mm front axle, and have seen the post about using late SS gear from speedo to go into 25mm housing. But i need a speedo for...

    Started by surfking, 06-05-2017 04:58 AM
    • Replies: 4
    • Views: 281
    06-05-2017 12:15 PM Go to last post
  18. Paint Protection Film - Opinions?

    Everyone, Good afternoon. I just purchased a 94 888 SPO Ltd. and want to keep the fairing pristine while getting in some miles. Have anyone...

    Started by DucFiend, 04-06-2017 05:15 PM
    • Replies: 3
    • Views: 305
    06-05-2017 02:45 AM Go to last post
  19. Dealer vs. Third Party Service

    Everyone, Two quick questions. What are your thoughts about dealer vs. third party services on your Duc? For some of the major stuff, I've had...

    Started by DucFiend, 04-06-2017 05:19 PM
    • Replies: 5
    • Views: 408
    06-05-2017 02:40 AM Go to last post
  20. 996rs crankshaft?

    is this a 'r' crankshaft? im building me a trackbike, so might be interested in it. second, does this fit in a st4s engine? (flywheel etc.?)

    Started by roen, 05-29-2017 01:43 PM
    • Replies: 8
    • Views: 556
    06-05-2017 01:40 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts