+ Post New Thread
Page 2 of 134
FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 52 102 ... LastLast
Threads 21 to 40 of 2669

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 24,901
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 10,612
    04-04-2012 05:22 AM Go to last post
  1. Interesting/disappointing dyno result....Mkll

    So after my initlial disappointing result here:...

    Started by seven4nineR, 08-08-2019 09:00 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 757
    08-19-2019 04:47 PM Go to last post
  2. P8 Tacho solution!

    ...

    Started by seven4nineR, 07-24-2019 01:41 AM
    • Replies: 4
    • Views: 255
    08-18-2019 09:29 AM Go to last post
  3. SP2 running lean below 5000 rpm

    Hi guys have recently purchased an SP2 that has been off the road for a couple of years. Took it to my local ducati shop to check valves, change...

    Started by fnqal, 03-04-2019 04:12 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 39
    • Views: 1,375
    08-17-2019 06:24 AM Go to last post
  4. Few misfires , Squezed vertical ignition cable

    Just going through the racer after 2 track days and by chance saw damage to the vertical ignition cable.. squeezed by the tank.. also I see some...

    Started by stiglarsenDK, 08-10-2019 11:24 AM
    • Replies: 1
    • Views: 76
    08-10-2019 12:59 PM Go to last post
  5. SP3 air hose

    Hello , My SP3 is mounted with the air hoses connected directly to the rubber inlet pipe. I saw a lot of SP3 climb like this. I tried to put it...

    Started by franck03, 07-31-2019 03:25 PM
    • Replies: 8
    • Views: 249
    08-08-2019 01:35 AM Go to last post
  6. 888 strada frame to racing conversion.

    Suppose I would like to converse a strada into a racing/corsa frame... what kind of metal should I use to fabricate the reinforcements/brackets...

    Started by Grinta, 08-02-2019 01:53 AM
    • Replies: 3
    • Views: 209
    08-02-2019 10:21 AM Go to last post
  7. Pistal HC kit for 888 SPO

    Hi, I want to do this mod to my SPO, anybody here did it? Do you recomend it? Tks

    Started by PISTER, 07-31-2019 07:01 AM
    • Replies: 1
    • Views: 116
    08-01-2019 09:19 PM Go to last post
  8. Cam bearings - Oil Channel 90 degree off ??

    Working on a set of 996 heads for the st4s bottom end..and have a set of cam bearings, which I recall comes from some 748RS or 916R heads... the oil...

    Started by stiglarsenDK, 07-27-2019 03:38 PM
    • Replies: 9
    • Views: 293
    08-01-2019 03:22 PM Go to last post
  9. Engine sensor connections question

    I have the following 2 cable Connectors on my wiring loom with an M and what looks like a C (might be an O) which connect to the 2 engine position...

    Started by Bridgland, 07-28-2019 11:46 AM
    • Replies: 4
    • Views: 114
    07-28-2019 01:58 PM Go to last post
  10. 82710131a

    Trying to track down this part, and am having no luck here across the pond... Any help would be most appreciated! :)

    Started by Seadweller, 07-16-2019 08:13 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 532
    07-24-2019 03:47 PM Go to last post
  11. Engine problems - irregular engine speed

    Hi. My ducati 851, 1989 has rolled 70000 km. The engine has always run smoothly, but lately the engine has begun to go irregular when it is not...

    Started by Fagertofta, 07-06-2017 11:21 AM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 1,527
    07-21-2019 03:28 PM Go to last post
  12. Heads up : Walbro Fuel Pump cracking - new Bosch type w connector as replacement

    Preparing 2 tanks with the internal guts. (small pump version tanks) Started checking 3 used walbro’s at hand, one of them dead. By chance i saw a...

    Started by stiglarsenDK, 07-20-2019 12:45 PM
    • Replies: 0
    • Views: 122
    07-20-2019 12:45 PM Go to last post
  13. Piston Wright - Add on

    I have sourced some HC pistals pistons for ST4s engine upgrade / drop in i was planning to do, yet they are 25 gram lighter than Stock... this would...

    Started by stiglarsenDK, 07-03-2019 11:05 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 435
    07-07-2019 05:50 PM Go to last post
  14. Draining Fuel Tank - '91 851

    What's the easiest way to completely drain the fuel tank, aside from running it dry? I'm going to be storing my 851 in my office, and don't want a...

    Started by Seadweller, 06-25-2019 10:12 AM
    • Replies: 3
    • Views: 358
    07-03-2019 12:20 AM Go to last post
  15. Original finish bolt sets

    Not sure this is the right section however am hoping someone has a lead on bolt sets other than Ducati dealer. Want original spec finish not...

    Started by tubbylad, 06-18-2019 05:49 PM
    • Replies: 5
    • Views: 279
    06-20-2019 07:23 AM Go to last post
  16. Intake and filter modifications

    ...

    Started by seven4nineR, 06-13-2019 03:41 PM
    • Replies: 0
    • Views: 194
    06-13-2019 03:41 PM Go to last post
  17. oil filter divert plate issue

    Hi am mounting an oil cooler on my 888. Have a question regarding the divert plate which goes above the filter. Do need to shorten the plate...

    Started by diabolik, 06-10-2019 10:24 AM
    • Replies: 4
    • Views: 208
    06-13-2019 03:03 PM Go to last post
  18. Belts and Valve Adjustment 851

    Any reason to worry about the valves on an 851 with 1,300 miles? I've read where adjusting the valves was necessary after a belt change, but not...

    Started by Seadweller, 06-07-2019 01:09 PM
    • Replies: 3
    • Views: 316
    06-11-2019 09:18 AM Go to last post
  19. LI-ion back to life

    Had the little battery sitting in a bike in storage(plenty for a racer) no life and special Li-ion charger giving fault, as if it was forever dead.....

    Started by stiglarsenDK, 06-10-2019 11:08 AM
    • Replies: 3
    • Views: 168
    06-11-2019 08:31 AM Go to last post
  20. St4s based engines, seeking advice on pistons and heads

    I’m working on another 2 st4s based engines for the track. Engine 1 Left side dual pick ups, RS flywheel and generator Crank 996RS w rods and...

    Started by stiglarsenDK, 06-05-2019 03:09 PM
    • Replies: 4
    • Views: 208
    06-10-2019 03:14 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts