+ Post New Thread
Page 11 of 127
FirstFirst ... 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 61 111 ... LastLast
Threads 201 to 220 of 2538

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 19,681
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 8,129
    04-04-2012 05:22 AM Go to last post
  1. What is this?

    What is the round hole on the right rear cowling for on my 888 Strada?

    Started by desmo54, 11-23-2016 02:19 AM
    • Replies: 7
    • Views: 813
    11-23-2016 03:56 PM Go to last post
  2. Need part of an 851/888 frame

    Looking for the back half of an 851 or 888 frame. Anyone with a bent frame laying around? Please see picture

    Started by Speedmade, 11-17-2016 08:11 AM
    • Replies: 1
    • Views: 457
    11-17-2016 08:18 PM Go to last post
  3. List/overview of Engine Bearings for SP5 ?

    Am looking for a list/overview and perhaps even each description of all the Engine Bearings inside the SP5 Engine Casing..... anyone of you Gentlemen...

    Started by 888SP5, 11-15-2016 08:15 AM
    bearings
    • Replies: 3
    • Views: 532
    11-16-2016 02:39 PM Go to last post
  4. Termignoni rivets for A08/B08 pipes

    Anyone know where to buy the blind rivets as used in A08/B08 SP3 pipes preferably in Australia?

    Started by pgw, 11-13-2016 11:41 PM
    • Replies: 1
    • Views: 356
    11-14-2016 03:08 AM Go to last post
  5. Anyone run 748r heads on an 888?

    I don't have the 0F cams but I do have the heads with 36/30 valves, I could fit them with A1 cams. Anyone tried it?

    Started by stafford, 11-05-2016 04:02 AM
    • Replies: 6
    • Views: 647
    11-12-2016 02:04 AM Go to last post
  6. High mounts on an '89 851

    Hi all, I've an '89 851, single seat with fixed exhaust hangers. Is there a later subframe that still allows the single seat, as well as different...

    Started by DeltaT, 11-02-2016 08:10 AM
    • Replies: 6
    • Views: 492
    11-07-2016 07:20 AM Go to last post
  7. AHRMA 2017 Rules

    So, I just saw this on the AHRMA site: "10.9.2.b.1 – Next Gen Superbike (engine) Change as follows: “Four-cylinder air- or oil-cooled machines...

    Started by JSR29, 11-02-2016 06:36 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 2,053
    11-05-2016 02:32 PM Go to last post
  8. Valve sizes

    Hallo, Might be a stupid question. But where does the size of the valves get taken. Like a 39mm valve is this then 39mm outside diameter or is...

    Started by henk, 11-04-2016 04:48 AM
    • Replies: 2
    • Views: 374
    11-04-2016 11:16 AM Go to last post
  9. 851 fuel pressure reguator problem

    Hi! I try to bring back an old 1991 851 S3 back to road, horrific optical and technical status....salt damages everywhere, "mechanics" had there...

    Started by Gernot, 10-08-2016 11:54 AM
    • Replies: 8
    • Views: 1,682
    10-30-2016 08:59 AM Go to last post
  10. Fuel Issues??

    Took my 888/955 for a ride on the weekend. Travelled 100kms north of Sydney and parked for the night on Saturday. Sunday on return trip rode 15kms...

    Started by Twigs, 10-17-2016 02:21 AM
    • Replies: 3
    • Views: 617
    10-21-2016 02:00 AM Go to last post
  11. Converting 900SS bodywork to 851/888 race style

    New to the forum, poked around a bit, tried a few search terms and I am sure I will eventually find something here but if anyone reading this can let...

    Started by RockAZ, 10-18-2016 03:30 PM
    • Replies: 3
    • Views: 678
    10-20-2016 01:32 AM Go to last post
  12. White wheel cleaning

    Good afternoon everyone, Not so much a technical question but there is a lot of caked on oil and gunk on the rear wheel of my 851. Of course...

    Started by lawman, 10-14-2016 11:56 PM
    • Replies: 4
    • Views: 525
    10-18-2016 03:37 PM Go to last post
  13. 851 MOT Pass

    Well my 1992 851 Strada passed it's MOT today - a bit of a surprise as I only recently bought the bike which had not run for at least 10 years. I...

    Started by cmd, 10-14-2016 10:43 AM
    • Replies: 1
    • Views: 369
    10-15-2016 09:47 AM Go to last post
  14. Front wheel rubbing chin piece on hard braking?!?

    The front wheel on my 888 is rubbing on the chin piece on hard braking? Tire is a Michelin Pilot Power 120/70. Forks are at factory height. (I...

    Started by freqrider, 10-08-2016 01:31 AM
    • Replies: 7
    • Views: 588
    10-14-2016 10:38 AM Go to last post
  15. rear brake bleed

    G'day guys, just replaced all the brake lines front and rear. Front brakes bleed no problems, good to go. Rear does not want to bleed. ie pumping...

    Started by redsp3, 10-07-2016 01:13 AM
    • Replies: 5
    • Views: 505
    10-09-2016 11:13 PM Go to last post
  16. Heads for my 888: 748 or 916?

    Hi guys, I want to prepare some heads with bigger valves for my 888SP3. A while ago I ran into a couple of 748 heads. I recently bought 36 mm and...

    Started by jakepeewee, 09-29-2016 10:49 AM
    2 Pages
    1 2
    • Replies: 19
    • Views: 1,283
    10-09-2016 08:08 AM Go to last post
  17. Brake light

    Hi guys, I'm new to the forum, but just bought a '91 851 after owning one back in 1990. Nostalgia got to me. My question regards the front brake...

    Started by Caper, 10-02-2016 08:48 AM
    • Replies: 4
    • Views: 675
    10-03-2016 01:22 PM Go to last post
  18. Courses

    Have tried the search function and cant find anything, so apologies if its all been said before. Ages ago, Tony Brancato used to run courses on...

    Started by neandethal, 10-01-2016 03:04 PM
    • Replies: 0
    • Views: 237
    10-01-2016 03:04 PM Go to last post
  19. Std silencer part stamp

    Can someone advise the correct stamped number on early M1r 851 silencers mine are stamped ZDM B04 and ZDM A04 are these correct if not what should...

    Started by veg, 10-01-2016 07:32 AM
    • Replies: 0
    • Views: 221
    10-01-2016 07:32 AM Go to last post
  20. How many different front fairings/windscreens?

    How many different front fairings/windscreens were there for these bikes? I have one windscreen which fits the Sharkskinz nose. Then I have the...

    Started by nine16, 09-28-2016 01:24 AM
    • Replies: 8
    • Views: 676
    10-01-2016 03:49 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts