+ Post New Thread
Page 101 of 131
FirstFirst ... 51 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 ... LastLast
Threads 2001 to 2020 of 2611

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 22,621
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 9,370
    04-04-2012 05:22 AM Go to last post
  1. tired 851 strada battery

    Well mine wont hold a good enough charge for more than a week or so & I dont want to damage the sprag clutch with an engine struggling to turn over,...

    Started by hipringle, 01-20-2010 12:53 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 2,671
    02-25-2010 03:12 PM Go to last post
  2. SP Flywheel

    Anyone knows if the flywheel below is fine for SP3 91'? It should be but I'm not sure........ I'd like to know the weight too? :)

    Started by SP91, 02-09-2010 06:41 AM
    • Replies: 3
    • Views: 601
    02-25-2010 12:39 PM Go to last post
  3. Exhaust part suppliers

    Hi Does anybody know of an exhaust parts supplier? Specifically inlet caps and outlet caps. I used AA16 a couple of years ago but they only seem to...

    Started by Andya, 02-24-2010 02:30 PM
    • Replies: 0
    • Views: 351
    02-24-2010 02:30 PM Go to last post
  4. Billet calipers

    Got the chance to buy these calipers. Will they bolt straight onto my SP4 Ohlins or will there be some hidden problems ( apart from a hole in my...

    Started by hedge hog, 02-21-2010 03:41 PM
    • Replies: 6
    • Views: 667
    02-21-2010 04:47 PM Go to last post
  5. Adjustable Rocker - Wrong Hoop

    I recently acquired an adjustable rocker but I do not have the correct hoop. So this leads me to two Questions, Firstly does any one have an...

    Started by phl851, 02-21-2010 08:08 AM
    • Replies: 2
    • Views: 1,104
    02-21-2010 02:10 PM Go to last post
  6. missfire

    Ive just taken the Duck ( SP 888) for its first real run and after about 2 miles of cruising speed there develops a major missfire which results in...

    Started by Whitto1, 02-13-2010 01:51 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,452
    02-21-2010 08:14 AM Go to last post
  7. Floating Disc Repair

    Hi Guys, After 16 years in the garage (while I was working overseas) I'm making progress on the old 1988 851; fuel pump, filter, and hoses have...

    Started by mal01, 02-19-2010 02:09 AM
    • Replies: 2
    • Views: 768
    02-20-2010 03:37 PM Go to last post
  8. Workshop Manuals

    Wasnt sure where to put this, so Technical it is. Available here to download for 3.50euros each are all sorts of workshop manuals. ...

    Started by yulie851, 02-19-2010 02:42 AM
    • Replies: 1
    • Views: 539
    02-19-2010 03:52 AM Go to last post
  9. Alternator Locking Tool - 1988 Tricolore

    Apologies if this is a repeat post, I'm looking for an Alternator Locking Tool for a 1988 Tricolore, the part no is 887130710. I've been told by...

    Started by mal01, 02-03-2010 07:56 AM
    • Replies: 9
    • Views: 1,202
    02-19-2010 01:55 AM Go to last post
  10. Dimensions top and bottom yoke

    Hi all, No bike to measure here:( But the motor is all back together:D Can somebody drop a note with the Ohlins fork diameters for the top...

    Started by guy851, 02-17-2010 03:33 AM
    • Replies: 2
    • Views: 894
    02-17-2010 04:46 AM Go to last post
  11. Dimensions wanted.

    With the rear wheel in place and all bolted up,can someone please give me the following dimensions: gap between swingarm inner faces-A gap...

    Started by Jasper, 02-12-2010 12:32 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 34
    • Views: 3,384
    02-15-2010 03:43 PM Go to last post
  12. rearset options

    Stuggling a bit with the brake side I was hoping to go 916 layout on the rear brake but it all fell apart. Today I thought sod it I can sort...

    Started by guy851, 03-21-2009 01:48 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,653
    02-15-2010 11:31 AM Go to last post
  13. Mysterious frame?

    Good evening, im not sure what frame i got? I think, it is a 851 frame but, foodpegmounts are 63mm no stearingstops 2 holders for the...

    Started by RED, 02-07-2010 12:46 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 1,013
    02-12-2010 03:43 PM Go to last post
  14. Corse Racing Yokes

    Hi all, Can anybody point me in the right date direction for these yokes with mag top + alloy bottom 25mm offset? I know that later bikes had a...

    Started by guy851, 02-11-2010 11:00 AM
    • Replies: 8
    • Views: 849
    02-12-2010 09:04 AM Go to last post
  15. Chip choise

    Hello I'd like to get suggestions about what chip I could use to replace the orignal ones. She is an SP3 with P7 ECU installed and, compared with...

    Started by SP91, 01-20-2010 04:59 AM
    3 Pages
    1 2 3
    • Replies: 27
    • Views: 3,755
    02-10-2010 04:58 AM Go to last post
  16. Ecu

    Hello all! Since a couple of weeks I finaly got on to working with my 1026 engine. When I putted the engine in the frame in september it would not...

    Started by hauge, 01-31-2010 11:21 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 2,276
    02-09-2010 02:33 AM Go to last post
  17. crank differences !

    okay may be a daft question to all you guru,s but we keep hearing of different cranks being put into different bikes ! so what cranks fit what and...

    Started by spike, 08-30-2009 04:38 AM
    7 Pages
    1 2 3 ... 7
    • Replies: 64
    • Views: 9,803
    02-06-2010 04:52 PM Go to last post
  18. Race tech G2R valve kit

    Yesterday was the big "lets get the forks working properly" day. The last time I pulled the 900ss showa adjustable forks apart was about 13 years...

    Started by griff851, 01-27-2010 04:50 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 2,057
    02-06-2010 03:11 PM Go to last post
  19. Need some help

    :confused: I'm switching out the top triple (yoke) on my 93 888 and I'm not excatly sure how the heck you remove the ignition from the triple? I'm...

    Started by Viper1, 02-03-2010 08:14 PM
    • Replies: 5
    • Views: 487
    02-04-2010 11:37 AM Go to last post
  20. Interchang. parts: speedo drive M1R fork 1990 851

    Hello I have just found a new speedo drive to sale in france. It fits 748; 916; 996; st2; st4; ss, as written on the packaging. Mine is a...

    Started by patrick, 01-19-2010 03:52 PM
    • Replies: 4
    • Views: 767
    02-02-2010 04:06 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts