+ Post New Thread
Page 10 of 128
FirstFirst 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 60 110 ... LastLast
Threads 181 to 200 of 2549

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 20,174
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 8,289
    04-04-2012 05:22 AM Go to last post
  1. External oil pipes on 851

    Continuing with the rebuild - my new battery cables have now arrived thanks to a link from this forum. I noticed when fitting them that the external...

    Started by cmd, 03-21-2017 12:11 PM
    • Replies: 1
    • Views: 194
    03-28-2017 03:15 PM Go to last post
  2. Tank questions

    I have a couple questions. First, I have a drip from the circled fitting. Internally, does a line run from that one to the fuel cap base? ...

    Started by nine16, 03-24-2017 09:52 PM
    • Replies: 1
    • Views: 228
    03-25-2017 10:05 AM Go to last post
  3. Slow turn over on 851

    I've been reading the posts on issues with the sprag on the 851/88 and I realised that when I go to try and start my 851 it does turn over veeeeery...

    Started by cmd, 03-17-2017 11:32 AM
    • Replies: 6
    • Views: 391
    03-24-2017 01:49 PM Go to last post
  4. Foam airfilter = lean condition?

    Greetings all! I just switched over to a UNI foam air filter and I noticed my bike (888 SPO) is now running a bit raw from 5-7000 rpms. My question...

    Started by freqrider, 03-18-2017 04:18 PM
    • Replies: 2
    • Views: 255
    03-20-2017 01:54 AM Go to last post
  5. Fuel pump woes

    My last post was about ECU issues. The latest saga is a fuel pump issue. I put a new ECU and chip in my 851. It's a 1992 ECU (P7) in a '91 851...

    Started by DezmoDog, 03-05-2017 04:54 PM
    • Replies: 6
    • Views: 440
    03-19-2017 08:01 PM Go to last post
  6. Sprag woes

    Sprag's crappin' out on me :( Not asking for advice, just venting! ;) Good side is. I bump started it and the forks I just overhauled with seals and...

    Started by freqrider, 02-09-2017 09:44 PM
    • Replies: 8
    • Views: 570
    03-17-2017 09:33 AM Go to last post
  7. Cometic head gasket questions.

    I am doing some maintenance in my 984 desmo quattro and i am installing cometic gaskets. The problem is that the rivet that keeps the together...

    Started by vij, 03-13-2017 09:08 AM
    • Replies: 2
    • Views: 212
    03-14-2017 03:21 PM Go to last post
  8. 851 engines

    I have 3 spare engines and wish to overhaul them. What are the members able to tell me about the engines from the numbers? What years they are...

    Started by customhead, 03-14-2016 06:59 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 2,115
    03-12-2017 10:04 AM Go to last post
  9. 1991 Ducati 851 / Showa Fork Replacement

    I've recently replaced the fork seals as part of a re-commissioning exercise and obviously removed the fork legs. I assumed that the service manual...

    Started by cmd, 03-07-2017 11:37 AM
    • Replies: 4
    • Views: 336
    03-07-2017 04:13 PM Go to last post
  10. Bevel

    Hi folk, I have a project that I have started, with a Darmah that is going down the modern rolling chassis route, I am fitting Online rsv front...

    Started by RWG, 03-01-2017 05:57 PM
    • Replies: 9
    • Views: 444
    03-03-2017 12:29 PM Go to last post
  11. Maxton M1R's or tuned Showa GD011's?

    As the title says. I initially read up on the Maxton treatment being around 300 so thought that would be the way forward. Got in touch with them and...

    Started by DeltaT, 01-04-2017 04:51 PM
    • Replies: 7
    • Views: 527
    03-01-2017 05:28 PM Go to last post
  12. 851 ECU Electronics nerd needed

    So here's my situation. After spending a ridiculous amount of time getting a new set of Termi slip ons mounted to an old bike, I proceeded to the...

    Started by DezmoDog, 02-26-2017 05:56 PM
    • Replies: 6
    • Views: 276
    02-28-2017 04:05 PM Go to last post
  13. Corsa Velocita|MadDuc 'quality' parts???

    I purchased this GP shifter from them a while back, where it sat on a shelf for a few years. I had it installed on my SPO for a year of sporadic...

    Started by freqrider, 02-27-2017 05:05 PM
    • Replies: 1
    • Views: 232
    02-28-2017 12:43 PM Go to last post
  14. Coughing 888

    I recently bought a '94 888 Strada. It was perfectly tuned, ran like a dream. Took it to a renowned Ducati mechanic to check the valve clearances. ...

    Started by desmo54, 01-09-2017 10:36 PM
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 2,212
    02-24-2017 03:06 PM Go to last post
  15. Correct Fr master cylinder SP2

    Can anyone confirm the correct front master cylinder for my SP2

    Started by leylandracer, 02-11-2017 10:20 AM
    • Replies: 3
    • Views: 419
    02-12-2017 01:56 PM Go to last post
  16. Corse pulley brackets

    I have a pair of corse pulley brackets, but they are not marked up v and o, can anyone tell me which one is for the vertical cylinder please? One has...

    Started by Jasper, 02-11-2017 02:59 PM
    • Replies: 4
    • Views: 255
    02-12-2017 02:10 AM Go to last post
  17. Replacement regulator/rectifier?

    I need to replace the regulator/rectifier on my 851 (1989 Strada) and am not sure which is currently the best option to buy - any advice? I...

    Started by rxs51, 02-07-2017 08:45 AM
    • Replies: 5
    • Views: 379
    02-08-2017 08:06 AM Go to last post
  18. Magnesium Can Bearing cap question

    Does anybody know why the Corsa cam bearing caps don't have an O Ring groove and why there is a lip or step on them?

    Started by Jasper, 02-06-2017 11:18 AM
    • Replies: 2
    • Views: 240
    02-06-2017 02:18 PM Go to last post
  19. fuel problem.

    Hi all, So I had the bike out on the weekend to go to this sea side town called Ragaln, it has the best coffee. The main reason was to try and...

    Started by jahrasti, 11-17-2016 12:37 AM
    • Replies: 9
    • Views: 1,005
    02-06-2017 07:00 AM Go to last post
  20. EEPROM - Std. 1989 851

    I've replaced my race cans with Standards ones. The bike appears to be running rich. So I'm after a std. EEPROM for a 851. Does anyone have any...

    Started by Mbracing748, 07-15-2015 06:44 AM
    • Replies: 7
    • Views: 957
    02-01-2017 05:04 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts