+ Post New Thread
Page 1 of 132
1 2 3 4 5 6 7 8 9 10 11 51 101 ... LastLast
Threads 1 to 20 of 2625

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 23,049
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 9,613
    04-04-2012 05:22 AM Go to last post
  1. SP2 running lean below 5000 rpm

    Hi guys have recently purchased an SP2 that has been off the road for a couple of years. Took it to my local ducati shop to check valves, change...

    Started by fnqal, 03-04-2019 04:12 AM
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 687
    Yesterday 02:31 PM Go to last post
  2. Confucious says building an 851 ace bike is expensive...

    ...but passing an 848 in a straight drag over the hill on our main straight? PRICELESS! Since the disappointing dyno result...

    Started by seven4nineR, 04-23-2019 08:33 PM
    • Replies: 3
    • Views: 103
    04-24-2019 07:26 AM Go to last post
  3. 851 Frame Identification

    Hello again, Newbie still searching for the right bike seeking the wisdom of the forum. With regards to the black label in the picture on the...

    Started by tubbylad, 04-23-2019 06:54 PM
    • Replies: 1
    • Views: 59
    04-24-2019 03:31 AM Go to last post
  4. Overhaul kit for rear brake master cylinder on SP3...

    Hello I want to overhaul the rear brake master cylinder on my SP3 - any idea where I can get an overhaul kit from? The item has this stamped on...

    Started by AndrewS, 04-23-2019 03:22 PM
    • Replies: 0
    • Views: 36
    04-23-2019 03:22 PM Go to last post
  5. Parts planiet silencers

    Just wondering if any of you guys on here have bought the silencers that parts planet in Italy sell?Would like to know what like they are in quality...

    Started by Jack888, 03-19-2019 02:18 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 332
    04-23-2019 02:29 PM Go to last post
  6. 916 crank in 851

    Hey guys, My 851 has 40k on it and have been contemplating going over the motor. Since Id be tearing into it, I figured it would be the time...

    Started by jsedacca, 04-22-2019 03:29 PM
    • Replies: 3
    • Views: 86
    04-23-2019 01:41 PM Go to last post
  7. New UK bikes in 92/ 93

    Looking for a little information if possible, In and around 1992/ 93 does anyone know who used to import new 888's for the UK market? Any info...

    Started by Jack888, 04-22-2019 04:52 PM
    • Replies: 9
    • Views: 138
    04-23-2019 11:53 AM Go to last post
  8. Sp4 Disc

    Hi Folk, Have just swopped my front disc for one of my spares sets: Question please, I have two sets of front disc's as spare and want to know...

    Started by RWG, 04-22-2019 12:52 PM
    • Replies: 2
    • Views: 76
    04-23-2019 04:23 AM Go to last post
  9. race bike performance upgrade 89 851 strada S3 motor

    hi looking for any easy upgrade options that we can make to 851 race bike, ECU, other. Trying to find bit more rwhp. cheers dan

    Started by danbrisbane, 04-10-2019 02:37 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 442
    04-21-2019 03:24 PM Go to last post
  10. At last, here it is!

    My book, at last available in English! By Veloce ...

    Started by BARONROJO, 03-30-2019 10:42 AM
    2 Pages
    1 2
    • Replies: 19
    • Views: 748
    04-20-2019 05:35 PM Go to last post
  11. ST4 engine exhaust issues

    Hi guys Got a '94 888 with a ST4 engine in. I bought the bike unfinished. The exhaust headers have issues. The vertical and horizontal cyl pipes...

    Started by econti, 04-11-2019 10:30 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 308
    04-20-2019 03:15 AM Go to last post
  12. New Hoods for voltage regulator plugs

    Hello Everyone, in the process to refurbish recently acquired '93 888 SPO. Going through the bike and replacing consumable. Found out that the...

    Started by Giar900ss, 04-13-2019 03:08 PM
    • Replies: 4
    • Views: 115
    04-17-2019 03:18 PM Go to last post
  13. Sprockets and chain combo

    All, In the process of putting my 888 Strada back together and about to get onto the rear wheel and associates gubbins. What recommendations...

    Started by Bridgland, 04-15-2019 11:00 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 159
    04-16-2019 07:23 AM Go to last post
  14. 851 strada resurrection.

    Hi , nooby here . I recently picked up a "barn find" '91 851 . It has been sitting for a minimum of 10 years in a storage facility . I have been in...

    Started by macsport44, 03-31-2019 10:45 PM
    • Replies: 9
    • Views: 301
    04-11-2019 06:56 AM Go to last post
  15. Reunited with an old friend. (1992 851 content)

    Hello all, I was recently reunited with my first love... my 1992 851! It's been sitting for 20 years (long story, driven by relocation from the...

    Started by PTwo, 12-07-2018 02:57 AM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 1,033
    04-08-2019 06:35 AM Go to last post
  16. Twin Injectors

    Maybe an odd question, but I thought I would ask anyway. Is it possible and is there any benefit to put twin injectors setup like the SP4/5 on a...

    Started by Bridgland, 02-13-2019 02:44 PM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 608
    03-30-2019 07:45 AM Go to last post
  17. New radiator

    Just fitting a new radiator to the 851/888 spgriffy. I forget what it’s off, late model V4 monster maybe. It’s got 2 fans (one’s going) and is way...

    Started by griff851, 03-03-2019 01:55 AM
    • Replies: 6
    • Views: 345
    03-28-2019 09:33 PM Go to last post
  18. determine oem ducati timing belt production date

    im wondering if theres a way to determine the production date of an oem ducati timing belt for ex. gates uses a code like 3514 DS 3= day 3...

    Started by Toni851, 03-21-2019 05:22 AM
    • Replies: 0
    • Views: 150
    03-21-2019 05:22 AM Go to last post
  19. Rear Tyre size for a 6" rim?

    Hi Everyone, I've been busying myself with a conversion, making a ST4S swinging arm fit a 851/888. This results in a swinging arm 15mm longer...

    Started by Mr.R, 10-18-2018 11:18 AM
    6 Pages
    1 2 3 ... 6
    • Replies: 50
    • Views: 1,626
    03-19-2019 01:20 PM Go to last post
  20. Oil cooler spring bypass

    Anyone have a photo of the oil cooler spring bypass fitted (sits above oil filter on Sp's)

    Started by Jack888, 03-16-2019 01:18 PM
    • Replies: 5
    • Views: 126
    03-16-2019 06:17 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts