+ Post New Thread
Page 1 of 124
1 2 3 4 5 6 7 8 9 10 11 51 101 ... LastLast
Threads 1 to 20 of 2463

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 10:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 14,668
    12-04-2012 11:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 05:21 PM
    • Replies: 4
    • Views: 6,807
    04-04-2012 06:22 AM Go to last post
  1. Lowering footpegs

    Just wondering if there's adapter plates or similar on the market to lower the 888 footpegs? Any advice on this appreciated. Cheers Jack

    Started by Jack888, Yesterday 03:46 PM
    • Replies: 2
    • Views: 45
    Today 08:31 AM Go to last post
  2. Bobbins corse/sps tank

    Can somebody give me some dimensions off those small bobbins that are on the 851 racing or SPS tank. The small alloy ones where those rubber straps...

    Started by henk, 12-09-2017 05:31 AM
    • Replies: 8
    • Views: 212
    Today 03:51 AM Go to last post
  3. Nikasil -

    Whats the process for reconditioning a barrel w Nikasil coating ? Can a woren 96mm cylinder be reconditioned to fresh 96mm (thinkess of coatings...

    Started by stiglarsenDK, 12-08-2017 11:42 AM
    • Replies: 4
    • Views: 164
    Yesterday 02:25 PM Go to last post
  4. Top End Refresh

    I pulled my heads+cylinders off to check and freshen up with new gaskets, seals and rings. This is the first Ducati engine i’ve ever taken apart and...

    Started by BTD, 11-15-2017 10:38 PM
    • Replies: 9
    • Views: 334
    12-12-2017 06:35 PM Go to last post
  5. steering damper

    Just looking for advice on which is the best way to go for a steering damper and fitting kit??, Would want it to be fitted to the right side helmet...

    Started by Jack888, 11-19-2017 07:42 AM
    • Replies: 5
    • Views: 205
    12-11-2017 01:38 PM Go to last post
  6. termignoni mesh

    hi there. i opened my termi's to put some fresh absorbing stuff in there. but in one muffler the fine mesh is gone. i did i search here and on...

    Started by roen, 12-10-2017 03:52 PM
    • Replies: 2
    • Views: 100
    12-11-2017 01:18 PM Go to last post
  7. 851 Battery Light staying on

    Over the last couple of days the battery light on my 851 has come on and stayed on. It's solidly lit, doesn't flicker or go out regardless of revs....

    Started by Kiwi Carguy, 12-09-2017 11:06 PM
    • Replies: 2
    • Views: 62
    12-10-2017 07:59 AM Go to last post
  8. SuperBike Accessory Sale

    Over here on the stagnant western edge of the big pond, this message just made the rounds: "In celebration of the twin cylinder Ducati Superbike...

    Started by tian647, 11-22-2017 12:28 AM
    • Replies: 6
    • Views: 355
    11-28-2017 02:12 PM Go to last post
  9. reference color white frame 851

    I am currently restoring my 851 of 1991. White frame therefore. I want to repaint the frame but I want to respect the right color. This is precisely...

    Started by Franck, 11-18-2017 01:59 PM
    • Replies: 1
    • Views: 98
    11-18-2017 03:19 PM Go to last post
  10. Underslung rear caliper

    Just wondering whats involved in converting to the underslung rear caliper on 1993 888? Are there kits available? Any advice would be appreciated,...

    Started by Jack888, 11-04-2017 04:51 AM
    • Replies: 2
    • Views: 217
    11-05-2017 12:28 PM Go to last post
  11. Spondon yoke set - Adjustable off set option, any good ?

    Got this adjustable Yoke set (Spondon made) It came with the FG43 legs i was after... not sure if yoke set is any good.. stiffness etc etc.. ...

    Started by stiglarsenDK, 09-15-2017 11:17 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 526
    11-05-2017 05:06 AM Go to last post
  12. Öhlins FG9050 oil level

    I've been overhauling mi 851 Öhlins fork today. I've found several oil capacities both in Ducati and Öhlins service manuals but not the more accurate...

    Started by BARONROJO, 10-11-2017 03:00 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 302
    11-02-2017 05:22 AM Go to last post
  13. "Race style" fuel caps and venting ?

    Hello All ! I am currently in the process of getting a 91 U.S. model 851 Sport (Strada elsewhere I believe ) back on the road and am thoroughly...

    Started by desmo4v, 07-11-2017 08:26 PM
    • Replies: 5
    • Views: 300
    10-26-2017 02:30 AM Go to last post
  14. Slight Engine Vibration when Leaning Over.

    I've been noticing slightly more engine vibration when I'm leaning the bike over through a turn. It dosen't have to be much. Slightly off axis in...

    Started by freqrider, 10-20-2017 08:22 PM
    • Replies: 5
    • Views: 197
    10-25-2017 11:24 AM Go to last post
  15. Rubber boot - for Air intake trompets

    My rubber boot's for the Strada Air intake trompets are cracking ... has any alternatives found ?

    Started by stiglarsenDK, 10-16-2017 09:45 AM
    • Replies: 6
    • Views: 260
    10-23-2017 08:38 PM Go to last post
  16. Monster S4 rear wheel

    Anyone tried swapping Monster S4 rear wheel to an 851/888? Not the ST2/3/4, not the Monster S2R/S4R... Pretty sure axle diameters are different,...

    Started by nine16, 10-18-2017 03:49 PM
    • Replies: 4
    • Views: 186
    10-19-2017 02:25 PM Go to last post
  17. 851 values ?

    Not sure if this is the right place for this question but I am trying to get an idea what my old 851 may be worth if I need to go ahead and sell it. ...

    Started by rxs51, 03-01-2017 08:24 AM
    • Replies: 9
    • Views: 473
    10-15-2017 11:17 AM Go to last post
  18. Workshop Manual Öhlins FG9030 - 9050 - 9100 - 9120

    Here the Manual

    Started by Rüdiger 900R, 10-13-2017 06:42 AM
    • Replies: 2
    • Views: 109
    10-13-2017 12:55 PM Go to last post
  19. Termignoni end can advice

    I have stripped down my 888 and when the cans came off there was a lot of loose material in each of them. Externally the cans are in pretty good...

    Started by Bridgland, 10-08-2017 04:55 AM
    • Replies: 6
    • Views: 249
    10-09-2017 11:47 PM Go to last post
  20. Rearsets off M900 Monster fit 888

    I have had several people say the M900 Monster rearsets will fit on an 888. Has anyone tried this, looked into this or had successs with M900 Monster...

    Started by MadDuc916, 10-03-2017 08:54 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 353
    10-07-2017 01:50 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts