+ Post New Thread
Page 1 of 133
1 2 3 4 5 6 7 8 9 10 11 51 101 ... LastLast
Threads 1 to 20 of 2644

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 23,893
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 10,092
    04-04-2012 05:22 AM Go to last post
  1. 82710131a

    Trying to track down this part, and am having no luck here across the pond... Any help would be most appreciated! :)

    Started by Seadweller, Yesterday 08:13 AM
    • Replies: 7
    • Views: 151
    Today 12:39 PM Go to last post
  2. Engine problems - irregular engine speed

    Hi. My ducati 851, 1989 has rolled 70000 km. The engine has always run smoothly, but lately the engine has begun to go irregular when it is not...

    Started by Fagertofta, 07-06-2017 11:21 AM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 1,195
    07-11-2019 01:14 PM Go to last post
  3. Piston Wright - Add on

    I have sourced some HC pistals pistons for ST4s engine upgrade / drop in i was planning to do, yet they are 25 gram lighter than Stock... this would...

    Started by stiglarsenDK, 07-03-2019 11:05 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 342
    07-07-2019 05:50 PM Go to last post
  4. Draining Fuel Tank - '91 851

    What's the easiest way to completely drain the fuel tank, aside from running it dry? I'm going to be storing my 851 in my office, and don't want a...

    Started by Seadweller, 06-25-2019 10:12 AM
    • Replies: 3
    • Views: 236
    07-03-2019 12:20 AM Go to last post
  5. Original finish bolt sets

    Not sure this is the right section however am hoping someone has a lead on bolt sets other than Ducati dealer. Want original spec finish not...

    Started by tubbylad, 06-18-2019 05:49 PM
    • Replies: 5
    • Views: 229
    06-20-2019 07:23 AM Go to last post
  6. Reproduction Full Floating 888 Brembo Disc Carriers

    All, After looking at all of the old threads on this topic and extensive searching on the web, it is clear there aren't any European companies...

    Started by Bridgland, 05-24-2019 07:12 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 634
    06-16-2019 02:34 PM Go to last post
  7. Intake and filter modifications

    Don't know if this will help anyone but it's a simple mod that costs bugger all and might be of interest if you run a Corse style intake/airbox. ...

    Started by seven4nineR, 06-13-2019 03:41 PM
    • Replies: 0
    • Views: 139
    06-13-2019 03:41 PM Go to last post
  8. oil filter divert plate issue

    Hi am mounting an oil cooler on my 888. Have a question regarding the divert plate which goes above the filter. Do need to shorten the plate...

    Started by diabolik, 06-10-2019 10:24 AM
    • Replies: 4
    • Views: 171
    06-13-2019 03:03 PM Go to last post
  9. Belts and Valve Adjustment 851

    Any reason to worry about the valves on an 851 with 1,300 miles? I've read where adjusting the valves was necessary after a belt change, but not...

    Started by Seadweller, 06-07-2019 01:09 PM
    • Replies: 3
    • Views: 231
    06-11-2019 09:18 AM Go to last post
  10. LI-ion back to life

    Had the little battery sitting in a bike in storage(plenty for a racer) no life and special Li-ion charger giving fault, as if it was forever dead.....

    Started by stiglarsenDK, 06-10-2019 11:08 AM
    • Replies: 3
    • Views: 134
    06-11-2019 08:31 AM Go to last post
  11. St4s based engines, seeking advice on pistons and heads

    I’m working on another 2 st4s based engines for the track. Engine 1 Left side dual pick ups, RS flywheel and generator Crank 996RS w rods and...

    Started by stiglarsenDK, 06-05-2019 03:09 PM
    • Replies: 4
    • Views: 169
    06-10-2019 03:14 PM Go to last post
  12. Help! ID carbon fuel tank fittings

    So I finally found an affordable carbon fuel tank (thanks Ducfactory, much appreciated!) to replace my porous alloy unit but I completely overlooked...

    Started by seven4nineR, 05-26-2019 07:13 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 508
    06-06-2019 07:20 AM Go to last post
  13. SP2 running lean below 5000 rpm

    Hi guys have recently purchased an SP2 that has been off the road for a couple of years. Took it to my local ducati shop to check valves, change...

    Started by fnqal, 03-04-2019 04:12 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 38
    • Views: 1,124
    05-31-2019 04:53 AM Go to last post
  14. Clutch slave cylinder rebuild/replace?

    Any ideas where I can get a rebuild kit for my '89 851 clutch slave. It's dumped fluid all over the cover and taken the satin black off. My fault for...

    Started by edzt, 05-27-2019 01:59 PM
    • Replies: 4
    • Views: 140
    05-29-2019 04:59 AM Go to last post
  15. Ohlins FG9050 complete restoration

    Hi, For my pleasure and because i'm a passionnate that love the perfects parts, I'm restoring my FG9050. Inside and outside. Full service,...

    Started by 854, 02-22-2016 03:12 PM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 5,234
    05-27-2019 03:47 AM Go to last post
  16. Does anyone reproduce air box funnels? Lost my airbox cover.

    Been working on my 851 and I freaking misplaced my airbox cover. Dunno why it should disappear. Everything else was in the box including the air...

    Started by dnaj11, 05-16-2019 08:40 AM
    • Replies: 6
    • Views: 281
    05-23-2019 09:11 AM Go to last post
  17. Exhaust - Racing

    Found this very used set of cans and manifold (50mm) and Will use if for a “death or glory” racer.. The original manifold (not a single scratch) has...

    Started by stiglarsenDK, 05-17-2019 03:42 AM
    • Replies: 3
    • Views: 209
    05-17-2019 02:26 PM Go to last post
  18. At last, here it is!

    My book, at last available in English! By Veloce ...

    Started by BARONROJO, 03-30-2019 10:42 AM
    3 Pages
    1 2 3
    • Replies: 28
    • Views: 1,325
    05-17-2019 09:57 AM Go to last post
  19. Valve clearance changes with cam rotation

    Hello, 1992 851, just finished with some head work and valve lapping. Reassembled heads and while doing the valve clearances, I found that one...

    Started by PTwo, 05-06-2019 07:25 AM
    • Replies: 6
    • Views: 236
    05-16-2019 04:29 PM Go to last post
  20. 851 strada resurrection.

    Hi , nooby here . I recently picked up a "barn find" '91 851 . It has been sitting for a minimum of 10 years in a storage facility . I have been in...

    Started by macsport44, 03-31-2019 10:45 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 539
    05-15-2019 06:23 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts