+ Post New Thread
Page 1 of 132
1 2 3 4 5 6 7 8 9 10 11 51 101 ... LastLast
Threads 1 to 20 of 2632

Forum: Technical Forum

  1. Sticky Thread Sticky: 851 M1r forks

    Hi Folks, After having worked on a few sets of the M1r forks, I thought I would post up some detail on what we found. The M1R are an...

    Started by NC Rick, 04-07-2011 09:13 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 23,296
    12-04-2012 10:13 AM Go to last post
  2. Sticky Thread Sticky: Sources

    One Tail, Brembo seal kits http://www.1tail.com/sa/c/Brembo.htm Bevell Heaven, Gasket kits, Steering head bearings, Fast shipping...

    Started by Jimmy, 05-03-2007 04:21 PM
    • Replies: 4
    • Views: 9,736
    04-04-2012 05:22 AM Go to last post
  1. Exhaust - Racing

    Found this very used set of cans and manifold (50mm) and Will use if for a “death or glory” racer.. The original manifold (not a single scratch) has...

    Started by stiglarsenDK, 05-17-2019 03:42 AM
    • Replies: 3
    • Views: 132
    05-17-2019 02:26 PM Go to last post
  2. Does anyone reproduce air box funnels? Lost my airbox cover.

    Been working on my 851 and I freaking misplaced my airbox cover. Dunno why it should disappear. Everything else was in the box including the air...

    Started by dnaj11, 05-16-2019 08:40 AM
    • Replies: 4
    • Views: 116
    05-17-2019 12:16 PM Go to last post
  3. At last, here it is!

    My book, at last available in English! By Veloce ...

    Started by BARONROJO, 03-30-2019 10:42 AM
    3 Pages
    1 2 3
    • Replies: 28
    • Views: 1,132
    05-17-2019 09:57 AM Go to last post
  4. Valve clearance changes with cam rotation

    Hello, 1992 851, just finished with some head work and valve lapping. Reassembled heads and while doing the valve clearances, I found that one...

    Started by PTwo, 05-06-2019 07:25 AM
    • Replies: 6
    • Views: 180
    05-16-2019 04:29 PM Go to last post
  5. 851 strada resurrection.

    Hi , nooby here . I recently picked up a "barn find" '91 851 . It has been sitting for a minimum of 10 years in a storage facility . I have been in...

    Started by macsport44, 03-31-2019 10:45 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 418
    05-15-2019 06:23 AM Go to last post
  6. Dream build

    Now thinking is not normally my forte but after finally getting my 851/926 race project on track...

    Started by seven4nineR, 05-05-2019 09:29 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 423
    05-13-2019 10:22 PM Go to last post
  7. Engine problems - irregular engine speed

    Hi. My ducati 851, 1989 has rolled 70000 km. The engine has always run smoothly, but lately the engine has begun to go irregular when it is not...

    Started by Fagertofta, 07-06-2017 11:21 AM
    2 Pages
    1 2
    • Replies: 18
    • Views: 805
    05-13-2019 11:38 AM Go to last post
  8. Which clutch and basket

    Hi all my 851sp3 has just clicked 20000 miles and at last service last yr lad said it was ready for new basket and clutch?! What and which 1 am I...

    Started by Pat 851 SP3, 02-09-2019 06:29 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 275
    05-13-2019 10:50 AM Go to last post
  9. Strange fuel pump return line issue

    Just finished up replacing the fuel pump in my 851 alloy tank with a similar 52mm pump from motoelectrics (BMW style pump). After reconnecting all...

    Started by jsedacca, 04-30-2019 01:47 PM
    • Replies: 6
    • Views: 196
    05-06-2019 03:30 PM Go to last post
  10. 888 & Supersport Rearset / Footrest interchangeable ?

    Does anyone know if the 1991 to 1997 Supersport rearsets (OEM) fit the 888 ? They look very similar and I think I have seen some aftermarket...

    Started by D4RKO, 05-04-2019 02:45 PM
    • Replies: 0
    • Views: 60
    05-04-2019 02:45 PM Go to last post
  11. Lowering footpegs

    Just wondering if there's adapter plates or similar on the market to lower the 888 footpegs? Any advice on this appreciated. Cheers Jack

    Started by Jack888, 12-13-2017 02:46 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,148
    05-03-2019 02:29 PM Go to last post
  12. 2&3 pole connectors, type and brand ?

    Working on the electrical for the st4s w 3 phase generator.. any insight around to who makes these 2 & 3 pole connectors for the RS rectifier unit.....

    Started by stiglarsenDK, 04-28-2019 02:43 PM
    • Replies: 3
    • Views: 121
    04-29-2019 01:48 PM Go to last post
  13. Sprockets and chain combo

    All, In the process of putting my 888 Strada back together and about to get onto the rear wheel and associates gubbins. What recommendations...

    Started by Bridgland, 04-15-2019 11:00 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 240
    04-28-2019 04:58 PM Go to last post
  14. SP2 running lean below 5000 rpm

    Hi guys have recently purchased an SP2 that has been off the road for a couple of years. Took it to my local ducati shop to check valves, change...

    Started by fnqal, 03-04-2019 04:12 AM
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 778
    04-25-2019 02:31 PM Go to last post
  15. Confucious says building an 851 ace bike is expensive...

    ...but passing an 848 in a straight drag over the hill on our main straight? PRICELESS! Since the disappointing dyno result...

    Started by seven4nineR, 04-23-2019 08:33 PM
    • Replies: 3
    • Views: 157
    04-24-2019 07:26 AM Go to last post
  16. 851 Frame Identification

    Hello again, Newbie still searching for the right bike seeking the wisdom of the forum. With regards to the black label in the picture on the...

    Started by tubbylad, 04-23-2019 06:54 PM
    • Replies: 1
    • Views: 86
    04-24-2019 03:31 AM Go to last post
  17. Overhaul kit for rear brake master cylinder on SP3...

    Hello I want to overhaul the rear brake master cylinder on my SP3 - any idea where I can get an overhaul kit from? The item has this stamped on...

    Started by AndrewS, 04-23-2019 03:22 PM
    • Replies: 0
    • Views: 55
    04-23-2019 03:22 PM Go to last post
  18. Parts planiet silencers

    Just wondering if any of you guys on here have bought the silencers that parts planet in Italy sell?Would like to know what like they are in quality...

    Started by Jack888, 03-19-2019 02:18 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 359
    04-23-2019 02:29 PM Go to last post
  19. 916 crank in 851

    Hey guys, My 851 has 40k on it and have been contemplating going over the motor. Since Id be tearing into it, I figured it would be the time...

    Started by jsedacca, 04-22-2019 03:29 PM
    • Replies: 3
    • Views: 111
    04-23-2019 01:41 PM Go to last post
  20. New UK bikes in 92/ 93

    Looking for a little information if possible, In and around 1992/ 93 does anyone know who used to import new 888's for the UK market? Any info...

    Started by Jack888, 04-22-2019 04:52 PM
    • Replies: 9
    • Views: 155
    04-23-2019 11:53 AM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts